PRINCIPLE Rate Calculator

Target Pest Selection

From the three below application sites, select your target pest.

Final Product Needed

Complete the fields above to calculate the low and high label rates according to the PRINCIPLE™ label. Units of measure can be altered both in the calculator and for final volume of product - please pay special attention to the final units used to apply the proper amount of product

Note: Your selected applicator is a fogger. To fog PRINCIPLE™ WP, follow these general best practices:

• Follow equipment manufacturer instructions and properly calibrate equipment regularly.
• Pre-mix/pre-slurry PRINCIPLE™ WP in a separate container to ensure full suspension of the active ingredient.
• Partially fill tank with agitator running prior to adding the PRINCIPLE™ WP slurry.
• Pour PRINCIPLE™ WP through a sieve to remove any remaining particulate prior to adding to the fogger tank.
• Consider using the maximum amount of water that a given machine allows to help ensure material is completely mixed and to improve coverage.

Read this guide for more detailed instructions:
PRINCIPLE™ WP: Use in low volume applicators

Total PRINCIPLE™ WP

For additional resources, see below:

• PRINCIPLE™ Information Page
• PRINCIPLE™ Best Application Methods
• PRINCIPLE™ Product Compatibility