PERpose Plus^™Rate Calculator

PERpose Plus™ Rate Calculator

Application Site

Sanitation

Horticulture/Agriculture

Application Type (Horticulture/Agriculture)

Spray

Dip

Drench

Application Type (Sanitation)

General Sanitation

Cooling Pad

Irrigation Systems

Application Subtype (Spray)

General Foliar

Cuttings and Plugs

Cut Flowers

Application Subtype (Dip)

Pre-plant Dip

Bare Root (Nursery Stock)

Application Subtype (Drench)

Soil Drench

Seedbed Treatment (pre-germination)

Seedbed Treatment (post germination)

Application Sub-Type (General Sanitation)

General Sanitation

Flats, Trays, and Pots

Cutting Tools

Foot Bath Mat

Application Sub-Type (Cooling Pad)

Cooling Pad (Existing Algae and Slime Contaminated Surfaces)

Cooling Pad (Water)

Application Sub-Type (Irrigation Systems)

Irrigation System (Clean/Continuous Injection)

Irrigation System (Contaminated)

Chemigation rates are the same for several different types of applications, such as over head boom-type sprayers or sprinklers, mist-type irrigation systems, sprinklers such as impact or microsprinklers, center pivot, lateral move, pressurized drench (flood) or drip (trickle) systems, furrow, micro-irrigation such as spaghetti-tube or individual tube irrigation, hand-held calibrated irrigation equipment, and more. See the PERpose Plus™ label for more applications types included under chemigation.

Injection Ratio

Skip this field if you will not being using an injector system. If you are planning on using an injector, what concentration is your injector adding the concentrate to the final solution?

Final Volume of Tank Mix

For injection, use volume of stock/concentrated solution.

Tank Mix Volume Units

Final Product Needed

Complete the fields above to calculate the low and high label rates according to the PERpose Plus™ label. Units of measure can be altered both in the calculator and for final volume of product - please pay special attention to the final units used to apply the proper amount of product

Total PERpose Plus™

Low Rate

High Rate

Units

Click here for more information about pot size assumptions for calculating volume requirements. Note that due to variation among manufacturers, pot sizes and drench amount are provided as a guide and are not intended to be an exact reference.

For shallow pots, apply at a rate of 50 - 100 gallons per 800 sq. ft. For deeper beds or pots, apply at a rate of 100 gallons per 400 sq. ft. The above volume of solution is our maximum recommended water for the given area/pot size and quantity.

The label is the law. This tool is intended to be supplementary to the label and help with it's interpretation - please refer back to the label to ensure correct application rates and application methods.

For additional resources, see below: